Car paint is usually baking paint. After the welding of the car frame and body is completed inside the car manufacturing factory, the next step is painting, generally speaking, the first step is primer. Dip the eggshell into a syrup shaped bathtub and remove the baking primer.

Then it is sent to the cleaning workshop and sprayed with paint using the electrostatic spray painting process. Then dry at around two hundred degrees. To complete more refined processing, you need to apply a layer of varnish. In this way, the process of painting is over.

Its process is not as messy as you imagine, and the following are the relevant processes:

1. Cleaning and judgment

After cleaning the vehicle, identify the type of old coating, evaluate the degree of damage to the workpiece, and determine the repair process.

2. Covering and degreasing

Cover the damaged area with masking paper and remove any oil stains from the area that needs to be polished.

3. Remove old paint and polish

Select suitable sandpaper and sanding machine to clean the old paint in the damaged area and polish it to the feather like edge.

4. Apply putty

After cleaning the workpiece and removing oil stains, select an appropriate amount of putty to scrape and dry with an infrared lamp.

5. Polish putty and old coating

Use a suitable sandpaper to smooth the putty with a sanding machine or manual sanding block. If it is necessary to apply putty again, it should be applied in a timely manner to absolutely prevent rework due to putty issues in the future.

6. Cleaning and degreasing

After polishing the workpiece, use an air gun to blow off the dust on the surface, use a degreaser to clean the area around the putty, and finally cover the area where the primer is required during spraying.

7. Spraying primer during spraying

If there are exposed metal parts on the workpiece, rust prevention treatment should be carried out first. After the rust prevention primer surface becomes dry, two to three layers of paint should be sprayed on the primer before it becomes dry.

8. Apply indicator layer and apply primer during polishing

After the intermediate layer is completely dry, apply or spray the indicator layer, and then select a suitable sandpaper and sanding machine to polish the primer.

9. Grinding the transition area

Based on the damage situation of the board, the correction process we selected is the board correction process. Therefore, in addition to polishing the skin flap, adjacent doors also need to be roughly ground.

10. Cleaning

After polishing and checking that there are no problems, clean the surface with clean water and blow dry.

11. Protection and degreasing

Secure the working components around the mudguard and front door using masking paper and masking tape. Then thoroughly clean the mudguard and degrease it.

Article source: Automotive repair paint http://www.qyjlxc.com